Lincoln Electric HELIX T55, Руководство оператора

Страница: 18 / 52

9 INSTALLATION 9
Torch Setup
Before welding ensure the torch is set up for opti-
mal weld parameters There are six adjustments that
can be set:
x
Fillet Weld Angle
x
Lead/Lag Angle
x
Torch Stick Out
x
Tungsten Stick Out
x
Torch Height
x
Wire Guides
Fillet Weld Angle
Before adjusting the Fillet Weld Angle hold firmly
onto the weld head to prevent damage. To set the
fillet weld angle of the torch loosen the fillet adjust-
ment bolt with a 5/16” hex key and set the angle as
desired. Swing up and tighten the bolt to clamp the
torch in place. Torch can be moved 110 degrees
out and 30 degrees in.
FIGURE 11 – FILLET WELD ANGLE
FIGURE 12 – FILLET WELD ANGLE 2
Lead Lag Angle
To set the lead/lag angle (see Figure 13 – Torch
Lead/Lag) of the torch loosen the barrel clamp bolts
with a 5/32” hex key on one side of the torch so that
the torch is free to rotate (see Figure 14 – Lead/Lag
Adjustment). Set the torch at the desired angle and
tighten the barrel clamp bolts to lock it in place.
There are markings in 5 degree increments to
achieve the desired angle. The lead lag angle can
be adjusted 360 degrees.
FIGURE 13 – TORCH LEAD/LAG
FIGURE 14 – LEAD/LAG ADJUSTMENT
Torch Stick Out
Adjust the torch stick-out after the controller has
been turned on and the oscillation has moved to
center position. Loosen the oscillation plate bolts on
top of the tractor with a 3/16” hex key and slide the