Lincoln Electric Growth Series, Инструкция по сборке

Страница: 58 / 94

Torchmate Growth Series
48
Assemble the (optional) 2X4 water table
In the following steps, you will assemble the water table if you purchased this option. The water table sup-
ports the CNC cutting table, supports the workpiece being cut, and safely eliminates nearly all of the sparks,
dust, and smoke during cutting. Eight steps are required to complete the water table assembly.
Assembly steps • The 2X4 water table is assembled in a series of easy steps.
• Step C1: Assemble the two end panels
• Step C2: Add a leveling foot to each leg
• Step C3: Attach legs to each end panel
• Step C4: Connect the end panel with legs to the side panels
• Step C5: Seal the water pan edge to the water pan bed
• Step C6: Install the drain valve and place the pan within the table
• Step C7: Add the material support slats.
• (Note: these slats are components you will cut to fit from local material, and are not
included in your shipment.)
• Step C8: Secure the cutting table to the water table
Required space • The completed water table is compact and can easily be assembled for use in a small
space. Its dimensions are: 37
9
⁄
16
" X 61
3
⁄
4
" X 30
5
⁄
16
"
• When planning for the table’s location, consider access to power for the plasma cutter
(208V or 230V / 1 or 3 phase / 50 or 60 Hz), power for the computer and CNC controller
(120 V), access to compressed air (and/or recommended gas), and how to obtain (and drain)
the water.