Lincoln Electric Growth Series, Инструкция по сборке

Страница: 30 / 94

Torchmate Growth Series
20
A B C D
The C steps for
the water table are optional
Step-by-step setup
The instructions presented here are arranged to be as simple as A–B–C–D: step-by-step. Assemble the cut-
ting table, Bind the Accumove2 controller to the table through the VMD software, Couple the cutting table to
the (optional) water table, and Deploy the selected tools. Each step presents a list of components and parts,
instructions for the step, and an illustration.
A-B-C-D steps • A steps— Assembling of the cutting table. This includes:
• Mechanically assembling the table sides and the gantry
• Performing the first set of adjustments.
• B steps— Binding the cutting table to the Accumove2 CNC controller. This involves:
• Establishing communication
• Connecting the motor cables
• Installing the VMD software
• Using the controller dynamically to adjust the table to get it square and tight
• C steps— Coupling the cutting table to the water table (optional) is next. In addition to
providing support for the workpiece being cut, the water table safely eliminates nearly all of
the sparks, dust, and smoke during cutting. It requires the following set of steps:
• Assemble the water table
• Cut material support slats
• Mount, square, and tighten the cutting table on the water table
• D steps— Deploy the selected tooling. The steps here vary by tool type:
• Mount the tool
• Run the cable(s), gas lines, etc.
• Set up the tool in the VMD software