IS726 ECN 4530
Page 3 of 10
WARNINGS AND PRECAUTIONS
This appliance must be installed, commissioned and serviced by a qualified person
with the installation instructions for the appliance and in accordance with national
and local regulations in force in the country of installation.
This appliance is intended for indoor use only and should never be installed
outdoors or exposed to the elements of nature. This unit must not be positioned in
an area that may be cleaned by a water jet and must not be cleaned by water jet.
The unit should be stood on a solid counter or shelf. Ensure that there is adequate
ventilation around the unit. In particular ensure that top and base are clear from
obstruction and ensure minimum of 50mm gap around the unit.
Do not install this unit close to any source of heat, which may result in operating
condition exceeding its design limits.
Ambient temperature range: minimum 16
0
C, maximum 32
0
C, Maximum relative
humidity 70%.
Switching on: If the unit has been laying on it’s side then allow at least 3 hours in
upright position before switching on.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person.
Ensure that the plug/socket is accessible at all times.
Strip plastic coating and clean the appliance before use.
This appliance contains R134a refrigerant under pressure. No part of unit should be
exposed to a naked flame. Maintenance of the refrigeration unit must be carried out
by an accredited service provider or qualified refrigeration engineer.
During operation parts may become hot - avoid accidental contact.
Always disconnect this appliance before servicing, maintenance or cleaning.
This appliance must be earthed.
Keep these instructions in safe place near the unit for future reference.