Page 6 of 20
Safety issues
The builder of the equipment shall ensure that the use of the component
complies with relevant standards – like the Machine Directive. Care must be
taken to avoid squeezing of cables as it can cause movement of the system!
The CBD6DC and the SMPS001/002/006 must not be packed in heat
insulating material, but must be placed so that they can emit waste heat to
the surroundings. There are no ventilation holes to consider, the CBD6DC/
SMPS emits heat through its surface.
Only the power supply type SMPS001, SMPS002 or SMPS006, shall be used
with the system.
Before installation, de-installation or troubleshooting:
• Stop the control box CBD6DC HOMELINE
®
.
• Disconnect the power supply.
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage is correct before the system is connected to the mains.
(See the CBD6DC HOMELINE
®
label in the appendix).
• System connection. The individual parts must be connected before connecting to
the mains.
During operation:
• If the control box makes unusual noise or smells, switch off the mains voltage
immediately.
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before it is moved.
Misc:
Updated manuals and declarations can always be found here:
www.linak.com/homeline