Before lifting, always make sure that the sling’s strap loops are correctly fastened to the sling bar hooks when the sling strap is
extended, but before the patient is lifted from the underlying surface.
For safety, load must be applied to all sling bar hooks during the lift!
Maximum load: 205 kg / 450 Ibs.
The SlingBar Mini 220 comes in two versions and with the intended use in
lifting small patients, for example
in a Liko™ TeddySling Low Mod 10.
SlingBar Mini 220 (Prod.No 3156005) can be used combined with a Liko ™ mobile lift or a Liko ™ overhead lift, with fixed assembly.
The SlingBar Mini 220 R2R (Prod.No 3156006) version is designed only for Room-to-Room transfers in combination with Likorall™ overhead lifts,
specified at page 2.
SlingBar Mini 220 complies with the requirements of EN ISO 10535
.
Product Description
IMPORTANT!
Read the instruction guide for both the patient lift and lifting accessories before use. Lifting and transferring a person always involves a
certain level of risk. It is important to completely understand the contents of the instruction guide. The equipment should be used by
trained personnel only. Please contact your Hill-Rom distributor in the event of any uncertainties or questions.
Assembly
Different maximum loads may apply to different products on the assembled lift system: lift, sling bar, sling and any other accessories used.
For the assembled lift system, the maximum load is always the lowest maximum load rating for any of the components. Study the markings
on the lift and lifting accessories or contact your Hill-Rom representative in the event of questions.
Safety Instructions
Continues on next page
SlingBar Mini 220
Instruction Guide
7EN160200
Rev. 1
ENGLISH 2015-08-11
Require, Fixed kit 4,
Prod. no. 3308860
NOTE!
Shall be assembled by personnel authorized by Hill-Rom!
Applies to following model:
SlingBar Mini 220
Prod. no. 3156005
SlingBar Mini 220 R2R
Prod. no. 3156006
(Prod. no. 3156005)
(Prod. no. 3156006)
Fixed assembly to:
Likorall™ 242 S overhead lift, Golvo™ mobile lift and (Viking™ mobile lift, Uno™ mobile lift)*
Tools required:
1 x
13 mm (1/2 inch.)
1 x
8 mm (5/16 inch.)
Adapter 12 mm,
Prod. No. 2016504
See applicable assembly instruction!
Fixed assembly to:
LikoGuard™ overhead lift
*
An Adapter 12 shall always be installed between the FlexLink and the Slingbar mini 220 to fixed assembly of Viking™ mobile lift and
Uno™ mobile lift, see below
FlexLink
Adapter 12 mm
SlingBar Mini 220
