Assembly Instructions
Step-3A - If using partitions as back panels.
Partition
Step-1
Ridged side
Base
When assembling a base, insert the connectors into the main board and two side boards.
The ridged side should be facing upward.
Main board
Side board
Connector
Step-2
Repeat Step-1 to complete the 3-Section Shoe / Accessory Grid.
※
Note: If using this product for Boot Storage, skip to the next page.
①
Flip the grid over and
insert 2 connectors
as shown below.
②
Place the partition into
the slot of the main board
as the back panel.
④
Insert the remaining
6 connectors.
Ridged side
Base
2 cubbies
Boot
For Boot Storage:
Follow the instructions on the back.
By excluding the main board
in the middle, the 2 cubbies
become Boot Storage.
Shoe / Accessory
Grid
-Section
3
Insert the partition
to the end.
Supply units
Supply units
Main board × 4
Side board × 6
Partition × 3
Connector × 16
The ridged side should
be facing upward.
③
Repeat
②
to finish inserting
the remaining 2 back panels.
