Assembly Instructions
Step-3A - If using partitions as back panels.
Step-1
When assembling a base, insert the connectors into the two main boards and three side boards.
The ridged side should be facing upward.
Step-2
2 cubbies
Boot
For Boot Storage:
Follow the instructions on the back.
By excluding the main board
in the middle, the 2 cubbies
become Boot Storage.
Shoe / Accessory
Grid
-Section
6
Base
Ridged side
Main board
Side board
Connector
Repeat Step-1 to complete the 6-Section Shoe / Accessory Grid.
Note: If using this product for Boot Storage, skip to the next page.
Base
Partition
Ridged side
Insert the partition
to the end.
Supply units
Main board × 8
Side board × 9
Partition × 6
Connector × 24
The ridged side should
be facing upward.
①
Flip the grid over and
insert 3 connectors
as shown below.
②
Place the partition into
the slot of the main board
as the back panel.
④
Insert the remaining
9 connectors.
③
Repeat
②
to finish inserting
the remaining 5 back panels.
