KIT MTAL
MAN KIT MTAL I_E 1.0
Pag.5
www.lika.it
www.lika.biz
User manual
MTAL
MTAL2
MTALH
KIT MTAL
1 Magnetic tape
Total length of the incremental magnetic tape MTAL
should exceed measuring length at least 30 mm
(1.2") each side.
The magnetic tape has been delivered in a roll and
can be cut to the desired length with any sheet
metal cutting tool.
The magnetic tape must be insert on the device hole
and fixed at the ends of the lift vane. The magnetic
tape must be free to slide into device.
The active side of magnetic tape (black side),
however installed, has to face the active part of
magnetic sensor on electronic board
Install sensor and magnetic tape according to the
above figure. The arrow shows positive counting
direction.
The system doesn't work if mounted incorrectly.
2 Fixing system
A
. Insert the magnetic tape in the rectangular slot
of the clamp base.
B
. Fold the magnetic tape at 90 degrees and insert
it in the proper seat.
C
. Lock the magnetic tape with the suitable vice
using the supplied screws.
connector arrow on
magnetic tape
