Lightway 872-S-G, Руководство пользователя

Страница: 11 / 17

Assembly Operation
20 21
3. Hold the wall bracket on the installation surface and mark
the three locations for fastening.
4. Drill two holes into the wall using a drill
19
and insert the
wall plugs
17
.
5. Screw the wall bracket to the fastening points with the
screws
18
as based on the properties of the installation
surface (see Fig. C). Use a cross-head screwdriver
20
for
this purpose. Do not apply excessive force in the process.
6. Slide the solar panel
15
and back cover from above
onto the wall bracket until you hear it click into place
(see Fig. C).
7. Completely unfold the charging cable and insert the
plug
14
into the charging slot
9
on the spotlight
7
.
Operation
Configuring the sensor area
1. If necessary, turn the motion sensor housing
10
to reach
the SENS controller
3
.
2. Select the required sensor area:
− Turning the SENS controller clockwise increases the
sensor area range and the motion sensor will already
react from a distance of approx. 12 m.
− Turning the SENS controller anticlockwise decreases
the sensor area range. With the lowest setting, the mo-
tion sensor only reacts starting at a distance of approx.
1 m.
To further adjust the sensor area, turn the motion sensor
housing
10
. The motion sensor housing can be turned by 90°
(see
Fig. D). The sensor angle of approx. 110° (+/-10°) does not
change in the process.
To avoid triggering the product unintentionally,
the product must be installed firmly. If the product
moves, this has the same effect as moving heat
sources in the sensor area.
Mounting the spot light
1. Choose a suitable surface for installation (see chapter
section “Selecting the installation location”).
2. Remove the rear panel
8
from the spotlight
7
by
unscrewing the fixing screw
6
.
3. Hold the rear panel (for wall installation) or wall bracket
13
(for corner installation) to the installation surface and
mark the installation locations.
4. Drill two holes into the wall using a drill
19
and insert the
wall plugs
17
.
5. Screw the rear panel or the wall bracket to the fastening
points with screws
18
as based on the properties of
the installation surface (see
Fig. B). Use a cross-head
screwdriver
20
for this purpose. Do not apply excessive
force in the process.
6. Attach the spotlight to the rear panel or wall bracket.
7. Use the fixing screw to fasten the spotlight and the rear
panel or wall bracket.
8. Tighten the fixing screw.
Mounting the solar panel
1. Choose a suitable surface for installation (see chapter
section “Selecting the installation location”).
2. Remove the wall bracket
16
from the back cover.
Press the plastic tab up slightly to do this.