6. Software Control – Lightware Device Controller
MX2-HDMI20 series – User's Manual
53
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
7.6.
Output Port Properties
7.6.1.
HDMI Outputs
Click on a port to display its properties.
Output port properties window
General Tab - General
Port name
The name of a port can be changed by typing the new name and clicking the
Set
button. The following
characters are allowed when naming: Letters (A-Z) and (a-z), hyphen (-), underscore (_), numbers (0-9), and
dot (.). Max length: 63 characters.
Mute
#mute #unmute
The incoming signal can be muted/unmuted by pressing the button. If the port is muted, button text is
Unmute
. In this case, no signal is transmitted to the output port.
Lock
#lock #unlock
The output port can be locked to the currently connected input port by the button. If the port is locked, button
text is
Unlock
. In this case the mute state and the crosspoint state of the port cannot be changed.
Last attached display EDID
The name of the last attached monitor's EDID is displayed (shown as
Monitor Name
in the EDID menu).
General Tab - Video settings
HDCP
#hdcp
▪
Depends on input:
the encryption level depends on the settings of the input port and the source content/
device. If the incoming signal is not encrypted, then the outgoing signal will not be encrypted either.
▪
Maximum possible:
the highest supported level of encryption (between the matrix and the sink) is
applied (up to HDCP v2.2).
Signal type
The outgoing signal format can be selected by a drop-down list:
Auto, HDMI, DVI.
5V enable
#power5v
▪
On:
+5V power is always sent thus the sink and the port are always connected.
▪
Off:
+5V power is not sent towards the sink, thus the sink does not sense the connection.
