Lightware MMX8x4-HT Series, Руководство пользователя

Страница: 66 / 163

5. Software Control – Lightware Device Controller MMX8x4-HT series – User's Manual 66
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
6.7.7. Microphone Input Channel
1
4
2
3 t
r
w
7
6
8
e
5
9
q
6.7.8. Legend of Microphone Input Channel
1
Channel name
Displays the channel name. All the settings below belongs to the channel.
2
Phantom power
button
Keep pressed the button for more then 2 sec to switch on and off the 48V DC. It gives
remote powering via the microphone cable to the condenser microphones.
ATTENTION! Application of the phantom power can cause a damage if dynamic or wireless microphone is
connected! # #analogaudio #balance volume #advancedaudio #mic #microphone
3
Phase invert
button
It inverts the phase of the input signal.
4
Feedback button Turning on this feature hides the Feedback phenomenon. Before applying this button, check
if gain or the volume could be decreased.
5
Preset Button Clicking on this button opens a
Mic Input Channel Preset
window. For more details see Channel
Presets section.
6
Gain section GAIN setting is for increase (or decrease) the input microphone signal level, expressed in dB.
For more information see Gain Settings .
7
HPF button High-pass filter lets pass the microphone signals above 100Hz frequency. Click on the button
to toggle turn it on and off.
LPF button Low-pass filter lets pass the microphone signals under 15kHz frequency. Click on the button
to toggle turn it on and off.
8
EQ section:
HIGH, HMID,
LMID, LOW
The equalizer section is for set the proper rate of the different
frequencies (high: 12kHz; high-mid: 1.6 kHz, low-mid: 400Hz, low: 120Hz).
For more details, see Equalization (EQ) Settings .
9
Mic preset Five factory presets are available for microphone input channel. These are specialized for the
most common microphone types. For more details see Factory MIC presets section.
q
Factory defaults
button
Restore the factory default settings on te microphone channel. For more details see Factory
Default Settings.
w
Input volume
fader
Sets the volume of the input microphone signal between -80dB and +10dB. It also can be
controlled by scrolling or writing the value in the text field.
e
Signal indicator
chart
This section gives a feedback about the actual level of the input signal. See more details in
Panorama or Balance Settings section.
r
Mute/Unmute Mutes/unmutes the microphone input.
t
Panorama
section
This setting defines, that the balanced microphone input is transmitted to the left or right
channel of the balanced analog output. For more details, see Panorama or Balance Settings .
ATTENTION! Not proper setting could damage the device! See more details about connect the microphone in
Installation Guide for Connecting a Microphone section.
  
