8. Firmware Upgrade
MMX6x2-HT series – User's Manual
78
Step 4.
Finish.
If the upgrade of a device is finished, the log can be opened by the
View
button on the right. When all the tasks
are finished, a window appears. Click
OK
to close and
Next
to display the summary page.
Clicking on the
Repeat
button starts the process again with the selected device(s).
The
Open logs
button opens the temporary folder where the logs can be found.
Export logs
by saving the files as a zipped file.
Press
Exit
to close the program.
ATTENTION!
However the device is rebooted after the firmware upgrade, switching it off and on again is
recommended.
8.5. Keeping the Configuration Settings
User can keep all configuration settings and restore to the device after firmware upgrading or can choose to
perform a factory reset – it means all settings will be erased in the device. In case of factory reset you can
save the settings of the device and restore it later. For the detailed information about saved data refer to the
section.
The following flow chart demonstrates how this function works in the background.
Flow chart of firmware upgrade
The details about the procedure:
when firmware upgrade starts, the
first step is making a backup of the
settings of the device. The firmware
package checks the backup data and
if it is needed, a conversion is applied
to avoid incompatibility problems
between the firmware versions. If you
do not want to keep configuration
settings, you can set the
Factory reset
option enabled.
The instruction in the firmware
package of the device will inform
you about this function availability,
reading it is highly recommended in
every case.
Instructions page in the firmware package
ATTENTION!
In specific cases restoring cannot be applied fully and certain settings are not copied back
to the device. If a warning message appears, user can get back the original data from the backup. Logs
of the upgrade procedure contain all backup data, it can be exported at the end of the upgrade procedure.
Details about the procedure of log exporting can be found in the
.
ATTENTION!
In certain cases, the new firmware version requires setting all parameters to set factory
defaults. In this case, the “Factory reset” option is enabled by default and not changeable by the user, see
ATTENTION!
The feature is supported from firmware version 1.1.1 together with LDU version 1.3.0.
Backup
Conversion/Restore
Start
Factory reset
End
Upgrading