Lightware MMX6x2-HT200, Руководство пользователя

Страница: 53 / 91

6. LW2 Programmers’ Reference MMX6x2-HT series – User's Manual 53
6.5. LW2 Commands – Quick Summary
General LW2 Commands
Operation See in section Command
View Product Type 6.2.1 {I}
View Serial Number 6.2.2 {S}
Query Control Protocol 6.2.3 {P_?}
View Firmware Version of the CPU 6.2.4 {F}
Connection Test 6.2.5 {PING}
Compile Time 6.2.6 {CT}
View Installed Board(s) 6.2.7 {IS}
View Firmware for all Controllers’ 6.2.8 {FC}
Restart the Matrix Router 6.2.9 {RST}
Query Health Status 6.2.10 {ST}
Restore Factory Default Settings 6.2.11 {FACTORY=ALL}
Port and Crosspoint Settings
Operation
See in section Command
Switch One Input to One Output 6.3.1 {<in>@<out>}
Mute Specified Output 6.3.2 {#<out>}
Unmute Specified Output 6.3.3 {+<out>}
Lock the Output 6.3.4 {#><out>}
Unlock the Output 6.3.5 {+<<out>}
View Connection State on the Output 6.3.6 {VC}
View Crosspoint Size 6.3.7 {getsize}
Batch Switch Outputs 6.3.8 {<in>@<out>}{<in>@<out>}
Change the Autoselect Mode 6.3.9 {AS_V<out>=<state>; <mode>}
Change the Video Input Priorities 6.3.10 {PRIO_V<out>=<in1_prio>;<in2_prio>;…;<inn_prio>}
Network Configuration
Operation
See in section Command
Query the Current IP Status 6.4.1 {IP_STAT=?}
Query the IP Address 6.4.2 {IP_ADDRESS=?}
Set the IP Address 6.4.3 {IP_ADDRESS=<type>;<ip_address>}
Query the Subnet Mask 6.4.4 {IP_NETMASK=?}
Set the Subnet Mask 6.4.5 {IP_NETMASK=<subnet_mask>}
Query the Gateway Address 6.4.6 {IP_GATEWAY=?}
Set the Gateway Address 6.4.7 {IP_GATEWAY=<gateway_addr>}
Query the TCP/IP Port 6.4.8
{LW2_PORT=?}
{LW3_PORT=?}
Set the TCP/IP Port 6.4.9
{LW2_PORT=<port_nr>}
{LW3_PORT=<port_nr>}
Query the Status of Ethernet Ports 6.4.10 {ETH_ENABLE=?}
Set the Status of Ethernet Ports 6.4.11
{ETH_ENABLE=<cpu>; <ctrl_tps_link>;<ctrl_lan>;
<tps_eth>;<tpsin1_eth>;<tpsin2_eth>;<tpsout1_eth>;
<tpsout2_eth>CrLf }
  
