Lightware DP-OPT-RX150, Руководство пользователя

Страница: 9 / 39

2. Product Overview DP-OPT-TX150, DP-OPT-RX150 – User's Manual 9
Applied firmware package: v1.1.13 | LDC software: v2.5.1b5
2.1. DP-OPT-TX150
Front View
1
POWER LED
▪
ON:
the unit is powered on.
▪
BLINKING:
an error has occurred and device is out of normal operation, or it is in bootload mode
(during firmware upgrade).
2 FIBER LINK LED
▪
ON:
the link is active between the extenders and ready to use.
▪
BLINKING:
is no connection between the extenders.
3 MONITOR LED
▪
ON:
a sink device is connected to the output port of the receiver.
4
HDCP LED
▪
ON:
DP signal transmission is in progress or HDCP encryption is enabled during DVI/HDMI transmission.
▪
OFF:
a DVI or HDMI display is connected to the receiver (via an adaptor cable) and HDCP is disabled
(thus the source is forced to send non-encrypted stream). For more information about the HDCP
setting, see the HDCP Setting section.
5 USB LINK LED
▪
ON:
HID extension is active.
▪
BLINKING:
the USB channel is ready to use but HID extension is not active (e.g. there is no USB HID
device connected to the receiver or the computer is powered off).
▪
OFF:
the USB channel between the extenders is not ready.
6 K+M EMULATE LED
▪
OFF:
the transmitter is in transparent USB mode (default).
▪
BLINKING:
the transmitter is in configuration USB mode; see the USB Modes section for more
information.
1 2 3 4 5 6
Rear View
1 DC connector Connect the output of the su5 V power adaptor. Lightware’s rack
mountable power supply can also be used (PSUx10-200 or PSUx20-400).
2
USB mini-B connector USB mini-B type connector. Connect to the computer if USB HUB or USB
KVM (HID) features are used. Control functions (with Lightware Device
Controller) and firmware upgrade are also performed through this connector.
3
Local USB-A ports The transmitter has a built-in USB HUB. These local USB 2.0 ports can be
used as extra USB ports connected to your computer but without extension.
4
DisplayPort input DisplayPort 1.1a input connector. Applied cable shall not be more than 2 m.
See the DP Input and Output Ports section for more information about the
connector.
5 SC Fiber connector SC fiber optical output connector. Connect to the receiver by a multimode
fiber cable.
1 2 4 5 3
  
