STANDARD REGISTRATION
FLEXMIKE REGISTRATION (OTHER REGISTERED COMPONENTS IN PLACE)
(Particularly valuable when Multimike is not easily accessible)
Note:
Multimike systems do not use MIC 2 status lights.
For users adding a second Flexmike or replacing a lost or malfunctioning Flexmike.
1.
Start with the Multimike plugged in and powered on.
2.
If replacing a Flexmike, make sure the malfunctioning Flexmike is powered off.
3.
If a other Flexmikes, Sharemikes or a Media Connector is present, power them
on and wait until each has a solid blue light (“Ready”).
4.
Power on the new Flexmike. The microphone 1 light should start blinking.
5.
Open the new Flexmike battery compartment and pull the battery out (leaving
it plugged in) to reveal the registration button.
9.
The registration is complete. You can begin speaking into the new
Flexmike to verify there is audio.
10. Place system ID number (attached to the Multimike Quickstart
Guide) on the new Flexmike.
NOTE:
if at any point, the Multimike or Flexmike lights begin
blinking rapidly, that indicates a registration error. Turn the new
Flexmike off and repeat steps 4-9.
Power On
Solid light
(Existing Good Flexmike)
6.
Use another registered functional component (existing Flexmike, Sharemike or
Media Connector) to trigger the registration function in Multimike.
• Using a paperclip with the end straightened out, press and hold the registration
button for 3 seconds inside the functioning Flexmike. This triggers registration in
the Multimike and the Multimike’s #1 amber light will begin blinking.
7.
Briefly press the registration button on the new or replacement Flexmike. The #1
blue light will start blinking alternately.
8.
After several seconds, the #1 light on the Multimike will turn solid and the #1 light on the Flexmike will remain blinking, then turn solid.
AUDIO IN
MICROPHONE
TONE
POWER
MIN
1
MAX
MIN
MAX
TREBLE
BASS
2
Solid lights
AUDIO IN
MICROPHONE
TONE
POWER
MIN
1
MAX
MIN
MAX
TREBLE
BASS
2
Blinking lights
Power On
Blinking lights
(NEW Flexmike)
Registration
Button
SYS
TEM ID#
SYS
TEM ID#
SYS
TEM ID#
SYS
TEM ID#
SYS
TEM ID#
RETAIN EXTRA LABELS IN THE EVENT A COMPONENT IS REPLACED OR ADDED.
Ma
tch components
to this system ID#
Apply to system components to indicate which parts are registered
as a system. Keep registered items together when storing away.
Registration ID Labels
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
334-0162-02-00-01
10101
MULTIMIKE REGISTRATION GUIDE
REGISTER
USB POWER
5V/0.2A
+
AUDIO IN
BAL. AUDIO OUT
AUDIO OUT
MIC LINE
AUDIO OUT/DC IN
USB POWER
5V/1.5A
