-‐ -‐ PRELIMINARY -‐ -‐
FireFly FF-‐301 Instructions and Specifications
QUICK START
If you’re one of those folks that just wants to start using your new FF-‐301 now and
read the instructions later, it’s quite easy to be up and running in literally seconds.
Three easy steps are all that are necessary for professional lightning simulation.
1)
Connect lights (up to 1500 watts per channel) to the left and right channel
socks on the rear of your FF-‐301
2)
Connect your amplifier or amplified speakers to the 1/8” stereo AUDIO
OUTPUT jack on the rear of the lightning simulator.
3)
Connect AC power.
No other connections or adjustments are required for basic operation.
WHEN POWERING UP…
Upon power up, the FF-‐301 goes through a quick self-‐test and the Lights-‐Alive logo
appears. After a total of approximately three seconds, the system is fully functional.
If the audio source was in the loop mode at power down, the 301 will begin
operation with no human intervention.
CUSTOMIZED SETTINGS
Five pushbuttons allow you to fully customize your FF-‐301 settings. Pressing the
center MENU button gives you access to twelve (12) additional windows. Pressing
the UP and DOWN buttons scrolls through the windows. The (+) and (–) buttons
alters the setting for that particular window. Pressing MENU again will exit the
program mode and save our changes. The windows in order are:
POWER OFF
Press the (+) button for a soft power down. In this mode, the simulator stops
all audio and does not trigger any lights. The LCD panel light is also
extinguished. The FF-‐301 will immediately resume operations when any of
the five pushbuttons are pressed.
