Page
2
of
5
FXLD336ZM3I LED FIXTURE
Version 0.1
OWNERS MANUAL
07/11/2011
www.lightronic.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
DMX TERMINATION
A DMX chain should be terminated at the last
receiving device on the chain. This is done by
installing a commonly available 1/4 Watt, 120 Ohm
resistor across the DATA - and DATA + wires at the
last device. If you have only a few fixtures very close
together and a very short run to the controller then you
may be able to operate without the terminator.
OPERATION
Operating options are set using the LED display and 4
buttons
(MENU, ENTER, UP, DOWN)
on the rear of
the fixture.
Push
MENU
to access the operating options. Then use
UP
and
DOWN
to scroll through the available choices.
When you reach the option you want to set or change -
push
ENTER
.
Now you can view the current setting
for the option and or change it. Push
ENTER
to save
your changes. Push
MENU
to return to the current
option display. See the "MENU NAVIGATION"
diagram for additional details.
There are 4 main operation modes: DMX, Auto
Program, Sound, Master/Slave. There is also a
provision to control the zoom function.
DMX OPERATION
Use the
ADDR
menu to set the starting address of the
unit. You can set the starting address of the unit with
the
UP
and
DOWN
buttons.
The fixture uses six DMX channels with allocations as
follows:
CHANNEL 1: 0 - 255 Master Level
CHANNEL 2: 0 - 255 Red Level (255 max.)
CHANNEL 3: 0 - 255 Green Level (255 max)
CHANNEL 4: 0 - 255 Blue Llevel (255 max.)
CHANNEL 5: 0 - 255 Strobe Effects
CHANNEL 6: 12º - 60º Zoom Control
ZOOM CONTROL
The fixture can zoom its beam diameter between 12
º
and 60
º
degrees. Use the
FoCS
menu to control it.
000 - 255 is the value range. 000 is 12
º
and 255 is 60
º.
AUTO PROGRAM OPERATION
Auto Program operation includes 14 (00 - 13) colors
and patterns which can be run. There are also speed
and fade sub-functions to control the selected program.
Use the
Pr - -
menu to select a program.
Use the
Sp - - and FA - -
menus to control the speed
and fade rates.
SOUND OPERATION
Use the
SOUA
menu to invoke the Sound Color
option. The unit will sequence through a series of
colors in sync with music base notes.
MASTER/SLAVE OPERATION
Connect the units together using DMX cables. Set all
the units to be slaved to DMX address 001. Set the
master unit to any auto operation option. The slave
units will sync to the masters operation.
MAINTENANCE AND REPAIR
TROUBLESHOOTING
Check that you have power applied to the unit.
Check the DMX control cable.
Check the address settings of the unit and the
controller.
FXLD336ZM3I REAR VIEW
