Page 2 of 6
FXLD127FRP5I2 LED FIXTURE
Version 1.0
OWNERS MANUAL
05/06/2019
www.lightronics.com
Lightronics Inc.
509 Central Drive, Virginia Beach, VA 23454
757 486 3588
received on the 3 pin MALE connector on the back of the
unit. The 3 pin FEMALE connector is used to connect to the
next DMX device on the control chain.
The table below shows the pin assignments for the 3 pin
DMX cable.
DMX TERMINATION
A DMX chain should be terminated at the last receiving
device on the chain. This is done by installing a commonly
available 1/4 Watt, 120 Ohm resistor across the DATA - and
DATA + wires at the last device. If you have only a few
fixtures very close together and a very short run to the
controller then you may be able to operate without the
terminator.
OPERATION
A control panel on the back of the unit is used to set the
operating options. It consists of an LED display and four
buttons (MENU, UP, DOWN, and ENTER)
Push MENU to access the operating options. When you
reach the option you want to set or change, press ENTER
and use UP or DOWN to set a value. Push ENTER again to
save your changes and activate the option. See the "MENU
NAVIGATION" diagram for additional details.
The fan on the unit will only turn on when temperature is at
or above 45° C and will turn back off at or below 34° C.
There are 7 operation modes: DMX 5 channel, DMX 9
channel, Color Fade, Color Change, Color Select, Manual
Level (6 selections), and Demo.
DMX OPERATION
For DMX operation the FXLD127FRP5I2 fixture can be
configured as a 5 channel or 9 channel unit. Use the
dXXX
(5 ch) or
AXXX
(9 ch) menu to set the starting address of
the unit. You can select the starting address of the unit with
the UP and DOWN buttons. Detailed information on DMX
channel operation is given in the tables DMX VALUES
AND FUNCTIONS.
MANUAL OPERATION
If there is no DMX signal provided to the unit then setting
any of these will result in the unit that was set to acting as a
master. DMX signals will override all manual settings. The
unit has an LED on the menu display (decimal point). If the
LED is flashing, the unit is not receiving signal either from a
DMX controller or from a master fixture. LED will
disappear once receiving signal is present.
Color Fade (CFXX)
The Color Fade mode cycles smoothly through a sequence
of colors. Use the
CFXX
menu to set the speed and activate
the option. The range is from 00 to 99 (99 is fastest).
Color Change (CCXX)
The Color Change mode switches continuously through a
sequence of colors. Use the
CCXX
menu to set the
sequence speed. The range is from 00 to 99 (99 is fastest).
Color Select (CSXX)
The Color Select
mode provides a multiple of
preprogrammed color macros at various intensities. Use the
CSXX
menu to set the desired color. Select color options
from 00-99.
R, G, B, W, A Manual Level Control
You can operate the individual color levels manually using
the
r000, G000, b000, E000,
and
Y000
menus. Use the UP
and DOWN buttons to change the level, Push ENTER when
done. The range is 000 - 255 (255 is maximum).
Demo Mode (dENo)
The unit cycles through a fixed series of color and fades.
There are no other adjustments or settings in this mode.
Sound Mode (SOUN)
The unit reacts to sounds by changing colors randomly.
There are no other settings within this mode.
PIN #
SIGNAL NAME
1
DMX COMMON
2
DMX DATA -
3
DMX DATA +
