Page 3 of 4
AS42L COMPACT DIMMER
Revision 2.2
OWNER’S MANUAL
06/01/2022
www.lightronics.com
Lightronics Inc.
509 Central Drive, Virginia Beach, VA 23454
Tel: 757 486 3588
switches. The bounce condition causes the chase
pattern to run in alternating directions.
The chase step time may be controlled for up to 64
seconds per step. Step fade time is proportional to
the step time. If a channel is in the relay mode
during chaser operation, it will “snap” on and off
(zero fade time). The tables below show the details
of chaser settings.
ADDRESS & CONTROL SWITCH SETTINGS
CHASER PATTERN SELECTION
CHASER TIMING SELECTION
SWITCHES
STEP TIME (Duration)
.5 seconds
1.0 seconds
2 seconds
4 seconds
8 seconds
16 seconds
32 seconds
64 seconds
MAINTENANCE AND REPAIR
TROUBLESHOOTING
•
Check that you have power applied to the
dimmer.
•
Check that all light fixtures are functional.
•
Check the fuses.
•
Check the control signal cable
•
Check the settings of the dimmer DIP Switches
•
Check the console setup for correct patching.
REPAIR
The only user serviceable parts are externally
accessible fuses. Replace fuses ONLY with 10
Amp, 250VAC, fast blow fuses. Internal service on
the unit by other than Lightronics authorized agents
will void the warranty. If service is required, contact
the dealer from whom you purchased the dimmer, or
Lightronics, Service Department, 509 Central Drive,
Virginia Beach, VA 23454. Tel: 757 486 3588.
WARRANTY INFORMATION AND
REGISTRATION – CLICK LINK BELOW
www.lightronics.com/warranty.html
NORMAL MODE SWITCH FUNCTIONS
RELAY C/D
RELAY A/B
(Up for relay)
NORMAL/CHASER
(down for normal)
ADDRESS
SWITCHES PATTERN
4 channel. sequence
4 channel. build
4 channel. build/unbuild
4 channel. random
3 channel. se
3 channel build
3 channel build/unbuild
2 channel alternating
CHASER MODE SWITCH FUNCTIONS
RELAY C/D
RELAY A/B
(Up for relay)
NORMAL/CHASER
(up for chaser)
BOUNCE
CHASER CHASER
PATTERN TIMING
