Lightmen Apollo, Инструкция по эксплуатации

Страница: 13 / 16

13
LIGHTMEN™
2.8 WIRELESS DMX OPERATION
apollo can operate in W-DMX mode up to 300m from the W-DMX transmitter. The W-DMX receiver in the apollo must
be paired with a W-DMX transmitter for wireless operation.
INITIAL SETUP
1. Turn on the W-DMX transmitter
2. Connect the W-DMX transmitter to a DMX controller
3. Position the Apollo fixture MAX 300m of the W-DMX transmitter in line of sight
4. Turn on the apollo fixture
CONFIGURATION
1. On the apollo control panel, go to DMX ADDRESS
2. Select the starting address
3. On the apollo control panel, go to WIRELESS SETTING
4. Set <Receive> to ON (the apollo signal indicator will display a ? above the bars)
5. Press the Reset button on the W-DMX transmitter
(the apollo signal indicator will change to a symbol above the bars while connection is establish)
PAIRING
Once successfully paired, the apollo signal indicator will indicate the strength of the signal. At this point, the apollo is
ready to be operated wirelessly by DMX. If the apollo fixture is subsequently used with a different W-DMX transmitter,
follow steps below.
1. On the apollo control panel, go to WIRELESS SETTING
2. Select <Reset> (the apollo signal indicator will display a ? above the bars)
3. Press the Reset button on the W-DMX transmitter
4. The apollo signal indicator will display the strength of the signal
once pairing has been successful
2.9 INFRARED IR6 REMOTE CONTROL
The IR6 infrared controller enables remote control of the apollo. To pair the IR6 to the apollo, follow these steps:
1. Press MENU button until IR Setup is displayed
2. Press ENTER
3. Press UP or DOWN to turn infrared operation ON or OFF
4. Press ENTER