ENGLISH
Set up:
Connect the product to the power supply and then turn it on. Wait until the heating element has
reached the operating temperature. The control is now carried out either by DMX, remote control
or by operation on the device itself.
It is imperative that you ensure that all cables used for commissioning (power and control) are
subject to the applicable regulations and are undamaged.
Place the product in a safe, ventilated place. Ensure that untrained personnel do not have access
to the product. Maintain a minimum distance of 50cm from walls and only operate the fog
machine on suitable, non-combustible surfaces. When installing on trusses, always use a safety
rope that complies with the regulations and approved sling material.
DMX mode:
Configuration oft he DMX connector:
Resistance 120 ohm // ¼ w between pin 2 (DMX-) and pin 3 (DMX+) oft he last fixture.
Connect the DMX input of your device to the DMX output of your DMX controller or interface.
Always use a DMX cable with a 110 Ohm resistor for this connection. Address the device
according to your DMX configuration. The following tables show the respective DMX modes of the
individual devices with the corresponding values and functions:
