Printer Setup
Make sure the printer is off. Then, press and hold the power button. The LED will flash rapidly, and then the printer will
print the Printer Setup report. The report shows the interface configuration (Bluetooth or RS232 / USB) at the top of the
document. The factory default is Bluetooth. If it shows as RS232 / USB, the printer is ready for use. Rapidly press the
power button twice to power off.
To change the Interface from Bluetooth to RS232 / USB, wait until the printing and flashing stop and press the power
button for ½ second and release. This should put the printer into setup mode and print the Interface as Bluetooth. Press
the power button one-tenth (1/10) second. The printer should print RS232 / USB on the paper and perform a short
linefeed. Press the power button for about ½-second. The printer should respond with a short linefeed followed by a
longer linefeed with button release. It will then print the next mode selection. Timing on these actions is critical so do not
pause too long or press too quickly. The paper should do a short “bump-up” when the button is pressed, and do a longer
linefeed when the button is released, and then print the next mode selection. Repeat this “long-press, release” until
PRINTER RESET is shown, which should skip the remaining steps and print each parameter until Printer Reset is printed
at the end of the report. The printer should power off and the settings will be saved.
For more information please contact:
Service and Support
Tel: 800-945-5905 (USA Toll Free)
Tel: 541-770-5905 (Outside of USA)
www.golighthouse.com
248083450-1
Rev
2
