3
Qualified professionals can install, operate and maintain the fixture, and to
make sure strictly in accordance with the procedures described in this
operating instructions.
The fixture should be installed in a well ventilated place, and the distance
from the wall to keep above 10 cm, at the same time, please check the fan
and the vent is unimpeded.
Do not use the fixture is directly projected on combustible objects, the
distance between the fixture and light objects please keep over 1 meter.
Don't look straight into the light source of the fixture (especially for epilepsy
patients), so as not to cause damage to the eyes!
Please do not open and fix the fixture by yourself.
For electrical parts connected person must have the corresponding
qualifications before operate.
For electrical parts connected person must have the corresponding
qualifications before operate.
Before installation, please make sure the power supply voltage you used and
the voltage of fixture is identified.
Every fixture should be properly grounded and in accordance with the
relevant standard for electrical installation.
Don't dispatch the fixture connected to any other dimming device.
Do not use insulating layer with damage for the power cord, and don't take the
power cord overlap on the other wire. When not use or to clean the fixture,
please unplug the power cord. Don't unplug the plug rudely or drag the
power cord directly.
Keep the bulb clean, do not contact with the glass bulb by hand directly.
Equipped with insurance rope connecting hole at the bottom of the fixture, for
security, please use safety cable to hang the fixture.
There is no any parts for repair inside the fixture. Before starting operation of
the fixture, please check whether all the cover plate (or housing) has been
installed well, whether the screw has been tighten .
Prohibit
use the fixture when the cover plate or housing is opened.
If you have any questions or Suggestions, please contact with dealers or
supplier