Light Sky FLY DRAGON IP2021Profile, Руководство пользователя

Страница: 28 / 30

-27-
It is recommended some solution for some normal trouble shooting. Any inextricability
problems should always be handling by the professional person. Disconnect the power
supply before maintenance the fixture.
■
LED off
/
LED
不亮：
◎ Please check if install the suitable voltage
检查是否安装了与灯具相匹配的电压；
◎ Please check whether the led will reach the end of their life can explode; please
replace a same description led.
检查灯具供电电源连接处或控制开关是否接触不良；
◎
Please check if the power supply is enough.
检查电力供应是否不足；
◎ Please check whether the DMX 512 controller pass the "turn on" order.
检查
DMX512
控制器是否发送了指令。
■
The fixture couldn't accept the control order:
灯具不接受控制器的指令：
◎ Please check the start code address and the function option are correct.
检查灯具数字启动地址数值和功能选项是否正确；
◎
Please check whether the communicate control cable is on good connection or the
cable is too long or interrupt.
检查通讯控制线路的连接情况是否正确、通讯线路过长或已经中断；
◎ Please check the control system is not valid, check the signal amplifier of chain
connected is valid.
检查控制设备是否失效，检查串连接入的信号放大器是否失效；
◎ Please check whether the communicate cable is too long or the other equipment is
mutually conjugate.
检查通讯线路是否过长或有其它设备相互干扰；
◎ Please arrange the wire well, shorter the signal cable, put the high voltage cable
and low voltage cable separately.
优化布线，缩短控制信号线的长度，高压与低压线路分开布线；
◎ Add the signal amplify isolator.
添加信号放大隔离器；
◎ Signal cable is used the excellent screening doublet (Resistance 75 OHM
）
信号线采用优质屏蔽双绞线(阻抗特性为
75
欧姆)；
◎ The end of the light end and the end resistance.
在灯具末端连接信号终端电阻。
■
The fixture can't move
/灯具不能启动
:
◎ Please check if the power supply is suitable for the light voltage data.
检查供电电源参数是否与灯具相符；
◎
Please check the light if they are deformation, inside parts is broken, become wet
etc will lead the loose contact.
检查灯具在长途运输过程中因挤压变形、内部零件震动、潮湿等原因，而导致接触不良
或脱落。
◎
Please check the if the iniside lead wire and the connector is loose.
请检查灯具内部导线积接插件是否脱落、松动。
◎ Please check the electric parts(such as the transformer,PCB board,contrller) is
short-circuit or burn down.
检查灯具电子元器件（如电子变压器、
PCB
板、电机控制板等）是否有松动、短路和烧坏
现象。
TROUBESHOOTING
/ 疑难处理