The products referred to in this manual conform to the European Community Directives to which
they are subject:
Low Voltage 2014/35/EU
Electromagnetic Compatibility 2014/30/EU
该产品符合欧洲共同体要求，遵守：
低压
2014
/
35
/
EU
电磁兼容性
2014
/
30
/
EU
Protection against explosion
预防炸裂
The protection screen, lens or uv screen on the lamp can be damaged to the degree of failure
if visible damage, such as a crack or deep mark, should be replaced
。
灯具上的保护屏、透镜或紫外线屏如果产生可见的损坏，即损坏到失效程度，如产生裂缝或
深痕时，应更换。
The light source in this xture shall be replaced by the manufacturer or its service agent or
similar qualication.
Always disconnect from mains before replacing the light.
此灯具内的光源应由制造商或其服务代理商或有类似资格的人来更换
更换光源前，请始终切断电源
Light
光 源
The maximun temperature that can be reached on the external surface of the fitting,
in a thermally steady state,is 80
℃。
Avoid contact bypersons and materials.
Allow the fixture to cool for at least 15 minutes before handling.
在热稳定的状态下，灯具外表面的温度最高点可达
80℃
。
避免直接接触灯体热表面。
让灯具冷却至少
15
分钟后再处理灯具（问题）
t
c
80℃
在开始任何维修工作或清洁灯具之前，必须切断灯具供电电源。
Never look directly into the light source. You risk injury to your retina, which may induce blindness.
请不要眼睛对看光源，它对眼睛网膜的损害可能会导致视盲。
Do not look at LEDs with magnifiers, telescopes, binoculars or similar optical instruments that may
concentrate the light output.
不要用放大镜、望远镜、双筒望远镜或类似的光学仪器来观察
LED
光源，这些仪器可以集中输出光。
Protection optical radiation
光辐射保护
