Connecting to the control signal line (DMX) - Fig. 5
◎
Please use the round 3 or 5-pin XLR plugs &sockets offered by menu facture to connect the first
projector's output to the second projector' input and connect the second projector's output to the
third projector's input. And in the same way for the rest,eventually connect the last projector's
output,all the projectors are together.
◎
The projectors's control signal output or input by using the 3 or 5-pin XLR pug and socket.If need to
lengthen the communication cable,please make sure the both side of 3 or 5-pin plug is one to one .
(one to one,two to two,three to three).Otherwise,the communication cable will be interrupted.The
communicate cable is 2-cord screened cable 75
¦
resistance with each core is at least a 0.5mm
diameter.(
Caution:
All the inside leading wire of 3 or 5-pin XLR plug couldn't touch each other or
plinth).
◎
Recommend to use the DMX signal terminator for the installation to avoid the electronic noise dama
-ge the digital control signal.Simply speaking,DMX terminator is an XLR connector with a 120
¦
1/2W
resistor connected across pin 2 and 3.Which is then plugged into the output socket on the last projec
-tor in the chain.Refer to the connection.
CONTROL PANEL
Press the switch. The projector starts resetting the effects. At the same time, the following
information scrolls on the display
:
(please refer to the actual material)
LCD series
Ј
PROFESSIONAL SHOW LIGHTING
DMX512
in
out
sig n al
end
out
in
in
USB
D i spl a y
Up arrowhead:page up
Down arrowhead:page down
Left arrowhead:reduce
Right arrowhead:increase
Enter:OK function
Exit:in the choice screen
DMX:
001
DMX Address
Information
Personal
Manual
control
Service
Lamp
Language
Reversal
www.lightsky.com.cn
10
Содержание BUMBLEBEE 2 Series
Страница 24: ...23 28V IN 28V OUT Electronic ballast Lamp 28V IN...
Страница 27: ...F230 F330...
