NOTE: Please make sure the power supply is turned off before installing
the lamp.
Clamp: 1pcs
Plastic cover: 1pcs
Lamp body: 1pcs
Screw: 1pcs
Spanner 8 mm, 5mm
& 2mm
FLAT gasket: 1pcs
Lamp head: 1pcs
Adapter: 1pcs
Adapter head (EU): 1pcs
Spring washer: 1pcs
Open the package and count the number of lamp accessories.
A:
Insert the lamp head into the lamp body.
B:
Connect the cable female and male connector.
Install the lamp body, plastic cover,clamp, flat gasket, spring
Washers, cylindrical head hexagon screws, with 5mm wrench to
lock them successively.
1
International warranty
Your product has gone through rigorous testing in order to live up to
the highest quality standards. It therefore carries a 7-year warranty
from the date of the original retail purchase receipt, covering defects
in materials and workmanship when used normally in accordance with
the published LIGHT-POINT guidelines.
These guidelines include but are not limited to information contained
in technical specications, safety instructions and quick start guides.
LIGHT-POINT is not responsible for damage arising from failure to
follow instructions relating to the use of the product.
LIGHT-POINT is a registered trademark of NORDIC LIVING GROUP.
For more information, please visit
LIGHT-POINT.COM
General use
·
The product is designed for indoor use only.
·
The lamp gets hot after prolonged use, therefore, do not cover the
product.
Cleaning instructions
·
Before cleaning, ensure that the power supply is switched off.
·
Wipe surface of lamp shade with a soft cloth.
·
Do not use any abrasive cleaning tools such as steel wool, scouring
sponges or stiff brushes.
·
Never use strong cleaning agents such as white spirit, household
glass cleaner or cellulose thinners.
Safety precautions
·
The appliance should be installed, connected and tested by
qualified electrician and in accordance with local regulations.
·
Turn off the power supply before installation or maintenance
of the lamp, and make sure that the cables are not squeezed or
damaged by sharp edges during installation.
·
The lamp should not be covered by insulation blankets or similar
materials.
Install the clamp on the table, plug in the power, touch the center
of the lamp holder to light up, long press to adjust brightness.
The lamp has a memory function, meaning it can remember your
last light intensity when turned off and on again
3
2
4
Installation Instructions
