7
ATTENTION: Remember to connect an XLR plug on the output signal
of the last fixture to terminate the DMX run. And make sure this XLR
plug is connected to a 120ohm resistance between terminals 2 and 3 of
the XLR plug. Terminating the DMX signal can avoid the signal flash
phenomena of DMX512 during operation.
7 Maintenance
Problems
Check list
Trouble Shooting
The fixture
does not
work
1. If your power setting
matches the input of the
Par.
2. If the fuse was broken.
1. Make sure the voltage is
correct.
2. Replace with the same
fuse.
LED
dimmed
If your power us same as
the input of the machine.
Make sure the voltage input.
No DMX
input
1. If the polarity is
opposite in the DMX
controller.
2. If it is in DMX mode.
3. If there are 2 Masters in
the chain.
1. Correct the DMX
polarity.
2. Change to the DMX
mode.
3. Set one piece into Slave
mode.
Par light
works
abnormally
1. Check if the light is
programmed correctly on
the control display
1. Program the Par correctly
based on the chart above