Page 5
3.0 Components
3.1 Baseplates are cast in steel and hot dip galvanized for long-term outdoor use. Cone
point stainless steel set screws secure the guardrail into the base plates.
3.2 Vertical posts are supplied with fittings and caps for a variety of configurations: by
placing the fittings on a vertical post, the 5 common “post” assemblies are created.
RGC-POST-END: Used where the horizontal pipes end at a vertical post, at the
ends of the system and ends of the tie-backs.
RGC-POST-90D: Used where the horizontal pipe make a 90-degree corner
RGC-POST-INT: Used where the pipe continues straight out on either side of the
vertical post.
RGC-POST-TB: Used where the pipe continues straight out on either side of the
vertical post, but there is a tie-back for stability.
RGC-POST-VAR: Used when the horizontal pipes meet at a vertical post at an
angle between 90 and 180 degrees
.
Figure 1 Figure 2
Figure 3
Figure 4
Figure 5
RGC-POST-END RGC-POST-90D RGC-POST-INT
RGC-POST-TB
RGC-POST-VAR