Lifetime FREESTANDING POWER LIFT 71730, Руководство пользователя с инструкциями по сборке, Страница: 3 / 32

SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions. Use
caution when using this system.
Owner must ensure that all players know and follow these rules for safe operation of
the system.
To ensure safety, do not attempt to assemble this system without following the
instructions carefully. Check entire box and inside all packing material for parts and/
or additional instruction material. Before beginning assembly, read the instructions
and identify parts using the hardware identifier and parts list in this document.
Proper and complete assembly, use and supervision are essential for proper
orientation and to reduce the risk of accident or injury. A high probability of serious
injury exists if this system is not installed, maintained, and operated properly.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE AND WILL VOID WARRANTY.
• If using a ladder during assembly, use extreme caution.
• Two capable adults are recommended for this operation.
• Check base daily for leakage. Leaks will cause system to fall.
• Assemble the pole sections properly. Failure to do so could cause the pole
sections to separate during play or transport.
• Minimum operational height is 7’6” (2.23m) to the rim.
POLE SECTION IDENTIFICATION
Identify the pole sections before beginning assembly. Failure to assemble the
pole sections correctly may result in severe personal injury or property damage
as described on Page Two.
ONCE THE POLE SECTIONS HAVE BEEN SEATED, THEY CANNOT
BE SEPARATED.
Note: Tapers and flares are exaggerated in the illustrations.
TP
mP
bP
Top Pole:
Four holes
at the top of
the pole, four
holes in the
middle, four
holes near the
bottom and
three small
holes at the
very bottom.
Middle Pole:
One slot at
the top of
the pole and
three small
holes at
the bottom.
Warning
Sticker.
Bottom
Pole:
One slot at
the top of
the pole and
four holes at
the bottom.
ZA
Zb
Top Pole
Brace:
” pole. Two
holes at the
top of the pole
and two small
holes at the
bottom.
Bottom Pole
Brace:
” pole. One
slot at the top
of the pole and
two holes at
the bottom.