6
Required For This Page:
1/2” Wrench
3
Turn the Backboard over so it faces up.
RI
JN
JN
4
5
RH
RH
AI
Slide the Compression
Springs (RI) onto the legs
of the U-Bolt or Hex Bolts.
6
Tighten the Nylock Flange Nuts
(RH) until the Rim is under the
desired tension.
7
RA
AE
RH (2)
RA (4)
HD9136B
Screwdriver
If the unit with the U-Bolt includes
Jam Nuts (pictured actual size
below) they are to be secured onto the ends
of the U-Bolt or Hex Bolts here.
JN
RD (2)
Fasten the Rim Cover Plate (AE)
to the Rim (AA) using the #7 x
3/8” Screws (RA).
1/2” Socket
Wrench
Use the 1/2” socket head from the
socket head wrench to press one
Push Nut (RD) onto one end of the Axle
(RJ).
2
RD
RJ
Note: The Push Nut should rest about 1/4” from the end
of the Axle. If the Push Nut slips on too far, continue
sliding it to the other end of the Axle to remove it and try
again.
RD
RJ
AH
AA
RJ
Slide the end of the Axle (RJ) through the Rim (AA) and the Rim Pivot Bracket (AH). Press the
Push Nut (RD) onto the end of the Axle. Use the 1/2” socket head to secure the Push Nut if
needed.
