Please read the operating instructions before using the
Surger Pro
.
Keep this manual for reference.
CHARGING THE BATTERY
• Fully charge your Surger Pro, for up 2 hours,
before using it for the first time.
• After the first charge, your Surger Pro will
take about 3 hours to charge.
• To charge, connect the AC charging adapter
to the port on the end of the Surger Pro and
to a wall outlet.
• The Surger Pro may be recharged at any time, regardless of battery level.
• The battery must be charged at least once every 3 months.
• Do not completely drain the battery before charging.
• Average run-time is 2 hours per charge at the highest speed level and 4
hours per charge at the lowest speed level.
• The Power Indicator will flash during charging. When the battery is fully
charged, the Battery Indicator will remain lit.
USING YOUR
SURGER PRO
1. Press the
Power/Speed butto
n on the end of the Surger Pro to power
on the device. The Power indicator LED will light up.
2. Press the
Power/Speed button
to toggle through the 5 vibration speed
levels: press once for speed level 1, twice for speed level 2, three times
for speed level 3, four times for speed level 4, and five times for speed
level 5.
3. Press the
Power/Speed button
a sixth time to turn off vibration.
3. At the desired vibration speed, roll a muscle group across the Surger
Pro. Apply pressure as needed.
4. The unit will auto shutdown after 10 minutes of use. To continue using,
just press the
Power/Speed button
to power on the unit again.
5. Always power off the unit after each use.
USING THE BLUETOOTH REMOTE CONTROL
1. Press the
Speed button
on the remote control five times rapidly to
connect it to the Surger Pro via Bluetooth.
2. Press the
Power/Speed button
on the Surger Pro to turn it on.
3. Press the
Speed button
on the remote control to toggle through the
five vibration speed levels: press once for speed level 1, twice for speed
level 2, three times for speed level 3, four times for speed level 4, and
five times for speed level 5.
4. Press the
Power/Speed button
on the Surger Pro to turn off the device.
NOTE:
The remote control has an adjustable wrist strap so you can wear it
around your wrist for hands-free use.
USING THE HEATING PAD
WITH THE SURGER PRO
1. Connect the heating pad’s USB cable to the USB output port on the
Surger Pro.
2. Press the
Power/Speed button
on the Surger Pro to turn it and the
heating pad will begin to heat.
3. Allow the heating pad to pre-heat for about 20–30 seconds.
4. Lay on the heating pad to warm up your muscles.
5. Begin your massage with the Surger Pro.
6. Press the
Power/Speed button
on the Surger Pro to turn off the foam
roller and heating pad immediately after use.
NOTE:
The heating pad temperature is 122° F.
NOTE:
The heating pad can only be used with the Surger Pro. Do not
connect the heating pad’s USB cable to any other USB output port.
10
Surger Pro
User Manual Lifepro
SoarFX Collection
11
Содержание SOARFX SURGER PRO
Страница 1: ...READY SET PRO U S E R M A N U A L...
