6
LumiCure User Manual Lifepro
Please read the operating instructions before using the LumiCure Light
Therapy Torch. Keep this manual for reference.
ATTACHING THE WRIST STRAP
1. Find the end of the wrist strap with the thin cord.
2. Insert the thin cord into the small wrist strap
hole at the base of the torch, and pull it through.
3. Insert the thicker end of the wrist strap through
the thin strap loop.
4. Pull the thicker end of the wrist strap through
the loop until the strap is secured to the
LumiCure.
CHARGING THE BATTERY
1. Insert a battery into battery charger according to
the polarity markings on the inside of the charger
(positive, +, end at the top).
2. Plug the charger into a standard wall outlet.
3. Allow the battery to charge completely, for
up to 5 hours. The Indicator LED on the front
of the charger turns solid green when fully
charged.
4. Unplug the charger.
5. Remove the battery from the charger.
WARNING:
Do not charge the battery for more
than 24 hours.
POWERING THE LUMICURE WITH THE CHARGED BATTERY
1. Hold the base of the LumiCure and unscrew the top section
of the torch with your other hand.
2. Insert the battery into the battery compartment with the
positive (+) end at the top as shown.
3. Replace top section of the LumiCure and screw it back on.
NOTE:
The average run-time is 3 hour of use-time per charge.
USING THE LUMICURE LIGHT THERAPY TORCH
1. Put on the protective glasses.
2. Place the therapy torch in position over the area to be treated,
ensuring that the side with the LED lights is touching or within 1
inch of your skin or clothing.
3. Press the
On/Off button
to turn on the device. The lights will turn
on. Two of the three lights will be visible to the human eye, but do
not stare directly at them.
4. Treatment time will vary depending on your pain level. The default
duration is 5 minutes. Refer to the chart below to determine your
treatment time and frequency.
5. Press the
On/Off button
to stop the therapy session at any time.
The LumiCure will automatically shut down after 5 minutes. Press
the
On/Off button
again after a 2-minute break if you wish to continue
using the device.
NOTE:
Do not operate the device for longer than 5 minutes. If
you wish to treat multiple body parts consecutively, turn off the
LumiCure for at least 2 minutes between treatment sessions to
prevent it from overheating.
6. Always power off the LumiCure after each use.
*
Be sure to wait at least 5 hours between treatment sessions on the
same area of the body.
Wellness Recovery Collection
7
Pain Level
Frequency
Once a day
Twice a day*
Three times a day*
Duration
1-minute treatment
time
2-minute treatment
time
3-minute treatment
time
Содержание LumiCure Light Therapy Torch
Страница 1: ...READY SET PRO U S E R M A N U A L...
