Lifepro DynaSphere, Руководство пользователя

Страница: 6 / 11

Please read the operating instructions before using the DynaSphere.
Keep this manual for reference.
CHARGING THE BATTERY
• Fully charge your DynaSphere for 4-5 hours before using it for the first time.
• After the first charge, your DynaSphere should typically take 4-5 hours to
charge.
• The Battery Indicator LEDs will flash during charging to indicate battery
level (e.g. when the battery is 80% charged, 5 of the 6 LEDs will be lit and the
remaining LED will flash). When the battery is fully charged, all 6 LEDs will
remain lit.
• The four Battery Indicator LEDs indicate the following battery levels:
• 6 LEDs lit = 100%
• 5 LEDs lit = 80%
• 4 LEDs lit = 60%
• For best results, charge the battery before it reaches 20%.
• Average run-time is 3-4 hours per charge at high speed and 6-7 hours at low
speed level.
USING YOUR DYNASPHERE
1. Twist the base of the DynaSphere’s handle to the ON position to power on
the unit. Once the unit is powered on, the Speed Indicator LEDs will flash to
prompt you to choose a speed level.
2. Press the Speed button once to set the vibration speed to level 1. The
Speed Indicator LEDs will indicate the speed level selected.
a. Press the Speed button a second time for speed level 2. Press a third
time for level 3. Press a fourth time for level 4. Press a fifth time for
level 5. Press a sixth time for level 6.
4. At the desired speed, float the head of the massage attachment along a
muscle group. Apply pressure as needed.
5. Twist the base of the handle to the OFF position to power off the unit.
6. Always power off the unit after each use.
10 DynaSphere User Manual Lifepro
REMOVING AND REPLACING
A MASSAGE ATTACHMENT
1. Twist the base of the handle to the OFF position to power off the unit.
2. Grab the inserted attachment and firmly pull out to remove it.
3. Insert the stem of a new attachment into the nozzle of the unit.
4. Press the attachment in firmly to secure it.
CHARGING YOUR CELL PHONE
1. Twist the base of the handle to the OFF position to power off the unit.
2. Open the silicone stopper covering the USB Charging Port.
3. Plug your phone’s USB charging cable into the standard USB port.
NOTE: The cell phone charging feature is only available when the DynaSphere is
powered off AND when the unit is not connected to power.
SoarFX Collection 11
TIPS FOR USING YOUR DYNASPHERE
• Move the DynaSphere over the desired muscle groups, about 60
seconds per region.
• The slower you move the massage head over your muscles the
better. Move approximately 1 inch per second.
• Apply pressure as needed; however, there should never be a need to
press very hard. The vibration pulses do all the hard work!
• Use the DynaSphere for 15-minute sessions, up to 3 times per day.
• Avoid keeping the massage head in one area for more than 3
minutes .
• Prolonged application can traumatize tissues.
• 3 LEDs lit = 40%
• 2 LEDs lit = 20%
• 1 LED lit = <5%