FILL THE WATER TANK
1. Fill water into the bottom water tank.
▲Notice: We recommend that you add water at the bottom. If you choose to add water at
the top, exceeding the " Max " water level will cause water leakage.
2. Fill the water tank with cold and clean water. Make sure that water level is between
“Min” minimum level and “ Max ” maximum level.
3. To increase the cool effect insert the ice box in the water tank. Before use ice box, they
must be filled by water and put in the refrigerator until they are completely frozen.
4. Close the water tank.
ATTENTION
1. Make sure the product is unplugged from the mains before filling or refilling the water.
2. Only use water in the water tank. Do not add any chemicals ,oils or other additives.
3. Only use cold water in the water tank. ( Previously boiled )
4. Make sure the water level in the water tank is between minimum level . ( Indicated by
“ Min ” ) and maximum level ( Indicated by “ Max ” )
Do not exceed the highest water level
Max
Do not fall below the lowest water level
- 7 -
- 8 -
PANEL CONTROL
Place the unit on a firm level surface and plug it into a socket. Power indicator light
reminding this products in standby mode. Turn on button, default setting is in middle
speed, Turn it again, products in standby.
Mode Button:
Default setting is in normal wind.
Press this button to set from normal wind, natural wind, sleep wind.
Cooling Button:
Press this button, start this function, and if you add the freezing ice
crystal box in the water tank,air blow out temperature will much more cooling.
Press it again to cancel the function. ( Make sure water level is above min.line )
Remote control and panel display:
Timer Button:
Press this button, the timer from 0 to 12 hours, each pressing 1hour.
Swing Button:
Press this button, the wind direction can swing flatly, and the swing
indicator light is on. Press again to cancel the function.
Speed Button:
Press this button to select middle, high, low fan speed.
Min
