S1:
S2:
Crown:
Time, Date Announcement and
Reception Status Button
Alarm and Set Button
Stop and Hands Reset Control
With the front of the watch facing towards you, you will notice the following buttons:
S1: Time, Date Announcement and Reception Status Button (this is located at the
2'clock position (top right)).
Crown: Stop and reset hands control (this is located at the 3 o'clock position (centre
right).
Pull this out to stop the watch and reset the hands.
Please note:
In some poor reception areas the signal may not update every night. Try
moving the watch to a new location. However, the watch is very accurate and
it can miss a few nights updating without any serious loss of accuracy.
Please note:
1. When the crown is pulled out, the watch hands stops while the internal
clock is still running. After you push-in the crown, the hands will turn quickly
to match the internal voice time automatically.
2. Whilst the hands are turning quickly do not pull out the crown. If the crown
is pulled out the second hand will stop. Pushing the crown back in will cause
the hands to turn quickly again to match the internal voice time automatically.
S2: Alarm (this is located at the 4 o'clock position (bottom right)).
Press this recessed button once and the watch will speak the alarm time that has
been set. If the alarm is turned off the watch will announce, "Alarm is off".
a. Press once to hear the hour and minute
b. Press twice to hear the day, month and date
c. Press three times to hear the reception status. If the radio signal reception was
successful the watch will speak the country name it is set to, followed by "Time
updated". If the radio signal reception failed the watch will speak the country
name it is set to, followed by "Time not updated".
Watch button S2 is flush with the watchcase and you will need to press this with a
pointer (such as a pen or opened out paper clip).
Orientation
Crown
S1
S2
ATOMIC
TALKING WATCH
01
