LifeGuard Lift LifeGuard Power Lift Series, Руководство пользователя

Страница: 4 / 17

5
9.
Bolt the foot rest to the flange under the seat with two
(2) 3/8” bolts with a washer on each side. Tighten the
bolts to 15-ft lbs. Make sure that the foot rest is
inside the flange.
10.
Install a fully charged battery and make two (2)
electrical connections.
11.
Make sure all mechanical and electrical connections are
secure.
12.
Cover the battery assembly with the removable battery
cover.
13.
Unlock the control box and operate the lift to make sure
it is working properly.
B. Setup
1.
Remove the anchor lid.
2.
Insert the bushing and then insert the mast into the
anchor.
3.
Attach the boom to the mast.
4.
Attach the actuator to the boom (if necessary).
5.
Attach the down tube/seat assembly to the boom.
6.
Install the battery, make the battery connections and
install the battery cover.
7.
Unlock the control box.
8.
The lift now is ready to operate.
C. Disassembly
NOTE: The actuator must be in the retracted position.
1.
Lock the controller, remove the battery cover, disconnect
and remove the battery.
2.
Detach and remove the down tube/seat assembly.
3.
Detach the actuator connection (if necessary) from the
boom and secure to the mast using the restraint strap.
4.
Detach and remove the boom.
5.
Remove the mast from the anchor.
6.
Remove the bushing and replace the anchor lid.