9
3. Handlebar Post, Handlebar Post Cover, and Tension Control Knob Installation
Remove four M8x10 Bolts (70) and four Ø8xØ16x1.5t Washers (10) from the Main Frame (1).
Remove bolts with the S6 Allen Wrench provided.
Slide the Handlebar Post Cover (58) up to the Handlebar Post (7).
Insert the Tension Cable (55) through into the bottom hole of Handlebar Post (7) and pull it
out from the square hole of Handlebar Post (7).
Connect the Sensor Wire (50) from the Main Frame (1) to the Extension Sensor Wire (63)
from the Handlebar Post (7).
Insert the Handlebar Post (7) onto the tube of the Main Frame (1) and secure with four
M8x10 Bolts (70) and four Ø8xØ16x1.5t Washers (10) that were removed. Tighten bolts
with the S6 Allen Wrench provided.
Slide the Handlebar Post Cover (58) down to the Handlebar Post (7).
Remove the M5x20 Bolt (40) and Ø5xØ15x1.0t Washer (41) from the Tension Control Knob
(54). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (54) into the spring hook of
Tension Cable (55), see Figure A. Pull the resistance cable of Tension Control Knob (54)
up and force it into the gap of metal bracket of Tension Cable (55), see Figure B. Attach the
Tension Control Knob (54) onto the Handlebar Post (7) with the M5x20 Bolt (40) and
Ø5xØ15x1.0t Washer (41) that were removed. Tighten bolt with the Multi Hex Tool with
Phillips Screwdriver provided.
63
41
40
54
10
70
10
19
A
B
54
55
55
54
55
1
70
50
63
7
Allen Wrench S6
Tool:
Multi Hex Tool with Phillips Screwdriver
