9
ASSEMBLY INSTRUCTIONS
Step 1
Remove the treadmill from the carton and place it on a level flat surface. Please always
use the aid of a second person when removing the treadmill from the carton.
Connect the Sensor Wire I (71) from the Base Frame (1) to the Sensor Wire II (72) from
the Right Handlebar Support Tube (4). It is recommended to have a second person assist
with this step. One person should hold the Right Handlebar Support Tube (4) in place
while the other person connects the sensor wires.
Insert the Right Handlebar Support Tube (4) into the Base Frame (1) and secure using two
Ø10 Flat Washers (19) and two M10x60 Hexagon Head Bolts (65). Semi-tighten bolts with
the Double Open End Wrench provided.
Insert the Left Handlebar Support Tube (3) onto the Base Frame (1) and secure using two
Ø10 Flat Washers (19) and two M10x60 Hexagon Head Bolts (65). Semi-tighten bolts with
the Double Open End Wrench provided.
WARNING:
When lowering right handlebar support tube onto the base frame,
ensure the sensor wires (71, 72) are not overlapping the frame, or they will be
pinched and cut when the handlebar support tube slides into position
NOTE:
DO NOT FULLY TIGHTEN BOLTS IN STEP 1 UNTIL THE STEP 2 IS
COMPLETE.
Hardware:
65 19
19
65
72
65 19
19
65
71
1
3
4
Double Open End Wrench
14-17
Tool:
(65) Hexagon Head Bolt
M10x60
4 PCS
(19) Flat Washer Ø10
4 PCS
