STEP ONE: Attach the electrical cords
Parts A, B, and C
3.
Connect the power cord, part A, that plugs into the electrical outlet directly into one side
of the converter. Connect the power cord from the base of the chair into the other side of the
converter. WARNING: To reduce the risk of electrical shock, do not connect the power cord to
an electrical outlet until all assembly instructions are completed. PLEASE STOP AND RE-READ
THIS INSTRUCTION: Do not connect the power cord to an electrical outlet until all instructions
of Steps One, Two, and Three are fully completed!
2.
Plug the Far Infrared Heat controller, part C, into the lower socket on the right-hand side of
the control box located on the bottom left hand side of the back of the chair.
1.
Plug the Recliner Remote Controller, part B, into the cord that comes out of the back of the
chair.
4.
In case of a power loss, we have included a battery back-up accessory to assist you in closing
the chair until electrical power has resumed. The battery backup accessory is activated when
you install two (2) 9-volt batteries (not included) in the Power Converter (Part A). Simply slide
open the cover to the battery compartment in the Power Converter box, attach the 9-volt
batteries, and close the cover.
PLEASE NOTE THE SAFETY INSTRUCTIONS BELOW.
CAUTION! READ AND FOLLOW THIS IMPORTANT SAFETY INSTRUCTION:
The controller plugs for the Far Infrared Heat and the Zero Gravity
Recliner described above are very similar. To avoid confusion,
frustration, and incorrect connections, please follow these instructions.
