the machine.
Layout:
Hold the rear of the frame with one hand, and then use your foot to gently push the
top of the hinged frame apart. The board will then automatically lower to the
ground.
C
aution
: Do not stand under the treadmill when unfolding.
7.
Checking V
-
belt and treadmill settings
If you seem to slip the treadmill, the next steps will determine which part is a release
and needs to tighten, if it's a running belt or a V
-
belt on the engine.
1.
Turn off the main switch off and unplug the power cord (out of the socket).
Loosen the side bolts on the engine guard and take down the cover.
2.
Turn on the treadmill again and set the speed to approximately 3km / h. Stand
on the belt and pull it firmly (pressure) to stop it.
3.
If the belt is paused along with the front roller, it means that is neccessary has to
be tensioned the V
-
belt.
4.
If the treadmill (area) is stopped but the front roller is still spinning it means
After completing this check and setting, screw the engine protection cover.
8.
Adjustment of the treadmill and adjustment the treadmill
deviation
Turn the two screws at the ends of the belt in the same direction by half a turn. If the
belt area still slips, repeat the previous step. At this adjustment, you can start the
belt at a speed of approximately 5
-
6 km / h.
a)
Belt tension
-
screw in clockwise direction.
b)
Loosen of the belt
-
screw bolt counterclockwise.
During the use of the belt, the running surface may deflect to the sides. In this case,
you must re
-
center it by following these steps:
1.
Place the belt on a horizontal surface and set the speed to approximately 5
-
6
km/h.
2.
If the treadmill swings to the right, rotate the right screw at the end of the belt a
half turn clockwise and left screw of a half turn counterclockwise.
