Page | 9
Step 8:
Tools Needed:
Philips screw driver: 2JAY
Note:
Ensure that all wires are properly
connected inside the console. Be careful not
to pinch the wires. Wires only connect one
way.
1) Locate bag labeled
Figure 8.
2) Locate computer console.
3) Connect the computer cable wire into the
connector on the board.
4) Place the computer console on the
console mast. Make sure the wires fit
inside the computer and computer
console sits flat on the console mast.
5) (
See Figure 8
) Secure four screws to the
back of the console using a Philips screw
driver. Tighten screws.
