2
2.2 Installing operator components
2.2.1 Mounting the operator on the runner
a) Open the operator hatch
(1)
and loosen the clamping screws
(2)
.
b) Then remove the cap
(3)
from the base, paying attention to the rear fitting of the
cover
(4)
with the base.
c) Remove the omega-shaped support brackets
(5)
by unscrewing the 4 screws
(6)
that fasten them to the base
(7)
.
d) M
ount the operator on the runner, introducing the protruding shaft of the operator
(8)
into the hole on the block
(9)
, taking care not to force the tab.
e) Fasten the operator to the runner using the omega-shaped support brackets
(5)
, fastening
it with the four hexagonal-headed screws
(6)
provided with the operator base
(7)
.
2.2.2 Automation installation
ATTENTION: the automation may only be installed once the various parts of the runner have been installed and the operator has been installed on the runner.
Sectional door:
a) T
he minimum vertical distance of the sectional door from the ceiling
A
is
40 mm
. If the distance exceeds the height of the brackets adequate spacers
must be used.
b) The vertical distance of the sectional door from the operator runner
B
must be between
10
and
65 mm
.
c) Close the door and measure out the centre point, marking it on the door and on the wall/ceiling.
d) At a distance of
73 mm
to the left and right of the centre, mark the centre of the fixing holes of the front runner brackets, then drill the holes and insert
the screw anchors.
6
5
7
9
8
7
5
1
3
6
4
2
B
A
40 mm
10 : 100 mm
73mm
73mm
