Life A82-LIFE-Dog Nebulizer, Руководство пользователя

Страница: 19 / 20

4. Hold the air intake near the nose (Figure 1-10). If using an optional mask, put the mask on the face (Figure 2-10). If using a
mouthpiece, hold it in the mouth {Figure 3-10).
5. Inhale the liquid medication moisture.
6. Whan liquid medication is depleted, turn the power switch to the off position.
NOTE: Far optimal performance operate the unit 20 minutes on then leave off for 40 minutes.
7. Unplug the power cord from the electrical outlet and tuck it into cord storage cavity.
S. Detach the tubing and accessory from the compressor unit.
9. Clean and sterilize tubing and accessories.
"OFF POSITION
CLEANING THE NEBULIZER COMPONENTS AND ACCESSORIES
1. Disconnect the tubing from the compressor and from the bottom of the nebulizer cup.
2. If there is any moisture (condensation) in the tubing, let the compressor run with the tubing only for 3-2 minutes. The warm
air from the compressor will dry out the tubing. Alternatively, you can dry the tubing by removing it from the compressor and
hanging it up with the «end8 down* to allow the moisture or condensation to drain out and evaporate. Use a clean damp
cloth to wipe the exterior of the tubing.
3. Disassemble tubing and accessories as illustrated.
4. Wash all parts with warm water and liquid dish soap. DO NOT WASH THE TUBING.
5. Rinse thoroughly with warm waterand shake out water.
6. Air dry or hand dry nebulizer parts on a clean, lint free cloth. Reassemble nebulizer when parts are dry and store.
7. You can also wash tha accessories in the top shelf of a dishwasher. Masks cannot be washad safely in a dishwasher. DO
NOT WASH THE TUBING. Place the parts in a dishwasher basket and place the basket on the top rack of the dishwasher.
Remove and dry parts when the cycle is complete.
DISINFECTING AND STERILIZING NEBULIZER COMPONENTS AND ACCESSORIES
1. Clean the nebulizer components and accessories as described in cleaning section. Every other treatment day, soak the parts
in a solution of 1 part distilled white vinegar and 3 parts hot tap water for 1 hour. DO NOT SOAK THE TUBING. You can
substitute commercially available respiratory equipment disinfectant for distilled white vinegar by following manufacturer›s
instructions for mixing.
2. Rinse all parts thoroughly with warm tap waterand dry with a clean, lint-free cloth. Discard vinegar solution when
disinfecting is complete.
3. Components (except tubing and mask) may also be sterilized by bailing them in clean water for a full 10 minutes. Hospitals
and clinics can sterilize components (except tubing and mask) by autoclaving (a maximum of °277F or °120C) and fallowing
autoclave manufacturer’s instructions. Dry parts on a clean, lint-free cloth.
4. Tubing and accessaries must be stored in a sterilizing box before using and must be sterilized periodically after u3e.