Precautions Prior to Mounting
Mounting Instructions (Reference Fig 1-8 Next Page)
・
2 People will be required to complete the mounting process.
・
Keep all packaging and packaging materials until you have inspected the heater and all the contents of
the mounting hardware.
・
The mounting hardware pack contains small items that should be kept away from young children.
・
Do not plug in or power up the heater until it is secure to the wall and the instructions are read fully.
・
Please choose a mounting location wisely, prior to starting. A power outlet must be within the
cord’s reach, but the heater must not be mounted over or within 12 inches above or below the
outlet.
・
Please observe the recommended heights and dimensions for mounting the heater.
・
This appliance is designed to be mounted to a wall at a minimum height of 8 inches from the floor.
・
Take necessary precautions to avoid cutting or damaging any cables or power cords.
・
While drilling holes for the mounting posts, be cautious of electrical lines, metals, or items beyond the
walls.
・
Be sure that the wall you choose to mount on is solid, and will support the heater’s weight of
approximately 13 lbs.
・
Make sure that the heater is safely out of the way while you are installing mounting hardware, as it
may become a tripping hazard if left in the open.
・
Please be cautious if you are set on mounting the heater low to the floor, as it may become a
safety hazard to children and pets!
**Note: If you do not have a second person to assist, you may use the dimensions on Fig. 7 as a guide to
mounting without awkward handling of the heater.
1.
Choose your mounting location based on the criteria in “Precautions Prior to Mounting.”
2.
Make sure when choosing your mounting location, that the distance between the bottom of the heater
and the floor will be no less than 8 inches when the heater is installed
3.
Once the mounting location is carefully picked out, and with assistance of a second person, lift the
heater, (with the flat side up against the wall) and straighten it using the small level.
4.
Mark the positions of the four holes to be drilled on the wall with the pencil or marker (Ref. Fig 1).
5.
At this point, lower the heater and place it where it will not be a tripping hazard.
6.
Using the power drill, and the bit included in your mounting hardware kit, drill the marked holes on
the wall (Ref. Fig 2).
7.
Insert the 4 plastic mounting posts into the holes. You should be able to press them in. If too difficult
to press, you may be able to lightly tap them in, using the screwdriver handle. (Ref. Fig 3)
8.
Line up and slide the heater onto the 4 mounting posts the four holes in the heater (switch side towards
the wall). (Ref. Fig 4)
9.
Once the heater is resting on the mounting posts, insert and tighten the screws onto the posts. (The
screwdriver is recommended to avoid stripping the posts or screw heads) (Ref. Fig 5)
10.
Install the plastic end caps onto the heads of the screws. It is recommended to use a bit of medium
strength glue to hold each cap in place. (Extra strength glue or “crazy glue” is not recommended, in
case you need to remove in the future) (Ref. Fig 6).
11.
Fig. 7 shows an outline of what the completed process should look like.
