Operating Your Grill
Your natural gas grill has been designed to operate on natural gas only, at a pressure of seven inches water column (7” W.C.). Check
with your gas utility for local gas pressure, because in some areas natural gas pressure varies. Also, check with your gas company or
with local building codes for instructions to install gas supply line or call a licensed and qualified installer.
It is recommended that an ON/OFF manual shut–off valve be installed at the gas supply source:
Outdoors after the gas line exits outside wall and before quick disconnect or before gas supply line enters ground.
Pipe sealing compound or pipe thread tape of the type resistant to the action of natural gas must be used on all male pipe
threads. Apply compound or tape to at least the first three to four threads when making connections.
Never store or use gasoline or other volatile substance in the vicinity of this grill.
Natural Gas Connection
Apply sealing compound or pipe thread tape of the type resistant to the action of natural gas must be used on all male pipe threads.
Attach to side burner valve. Connect the other end of the flex hose to manual shut-off valve through a nipple. Connect a manual
shutoff valve to gas supply line.
During high pressure testing your gas grill and its individual shutoff valve must be disconnected from the gas supply piping
system. During any pressure testing of that system at least pressures in excess of 1/2 psi (3.5kPa).
During low pressure testing your gas grill must be isolated from the gas supply piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5kPa).
Warning
: Burner valves are pre-tested at the factory to operate on natural gas. If you wish to convert or change it, be sure to
contact your grill distributor or dealer FIRST!
GSC3218JBN
14
Owner’s Manual
