Figure 1
MO51-00K26-A262
Figure 2
Life Fitness Model 9100 Series Treadmill
How To…INSTALL WAX NOZZLE BRACE
Tools Required:
Hex Key wrench set, combination wrench set.
GK26-00002-0060
Step 1
Turn the ON/OFF switch to the OFF position and disconnect the line-cord from the wall receptacle.
Step 2
Remove the 4 SCREWS securing the MOTOR SHROUD. Remove MOTOR SHROUD and set aside.
Step 3
Remove the tension from the STRIDING BELT by turning each ROLLER TENSION BOLT eight rotations in a
counter clockwise direction.
Step 4
Remove the 4 SCREWS and WASHERS securing the DECK. Remove the DECK.
Step 5
Remove and clean the WAX NOZZLE. Set it aside to be re-installed later.
Step 6 ( Figure 1)
Shift STRIDING BELT to one side to gain access to the WAX NOZZLE BRACKET. Using the NOZZLE BRACE as
a gauge, hold it flush against the bottom of the WAX NOZZLE BRACKET and position it against the angle of the
BRACKET TAB. This will determine the amount of bend required to change the angle of the BRACKET TAB so that
it matches the angle on the NOZZLE BRACE.
Step 7 (Figure 2)
Position a 9/16 box end wrench over the cylinder portion
of the BRACKET TAB and gently bend to the determined
amount from Step 6.
Step 8 ( Figure 1)
Insert NOZZLE BRACE to ensure that the WAX NOZZLE
BRACKET is bent to the proper angle.(
Repeat steps 6
and 7 as required.)
Step 9 ( Figure 1)
Center the NOZZLE BRACE against the BRACKET TAB
and secure the NOZZLE BRACE to the WAX NOZZLE
BRACKET with 2 TINNERMAN CLIPS. The TINNERMAN
CLIPS should be flush with both the WAX NOZZLE
BRACKET and NOZZLE BRACE.
Step 10
Re-install cleaned WAX NOZZLE.
Step 11
Install the deck and secure with mounting bolts.
Step 12
Center STRIDING BELT, then tension by turning each REAR
ROLLER TENSION BOLT eight rotations in a clockwise
direction.
Step 13
Re-install the MOTOR SHROUD and secure with 4 screws.
Step 14
Track or tension STRIDING BELT as necessary. Refer to
“How To“ in a Service or Operation manual for proper
procedure.
Tinnerman
Clips
Nozzle
Brace
Wax Nozzle
Bracket
Direction
Of Bend
Wax Nozzle
Bracket
9/16 Box
Wrench
Bracket Tab
