Dynamic HST Safety Stud Anchor Procedure
1.
Place unit into position to be mounted and cycle unit to set stance.
2.
If necessary, cut HST Safety Stud Anchor to length before installation, leaving enough length to ensure proper
concrete embedment (see
Anchor Section
for embedment depth required) and proper tightening torque (44 Foot-
Pounds/60Nm).
3.
Wearing protective glasses, drill down into flooring perpendicularly to the required depth, ensuring that the foot
thickness is being accounted for; refer to
Anchor Selection
and
Foot Dimensions
.
4.
Clear out the debris from hole and then insert fastener and hammer into hole until flush against frame plate.
5.
Tighten to 44 Foot-Pounds (60Nm).
6.
If necessary, cut extra length from top of anchor with a rotary tool leaving proper concrete engagement and torque
requirements.
7.
Re-tighten anchor to 44 Foot-Pounds (60Nm).
Page 26 of 27
Содержание SMSS-ADD
Страница 2: ......
Страница 29: ...Foot Dimensions Use below image to determine foot specifications Page 27 of 27 ...
Страница 30: ......
