1.
Before proceeding, familiarize yourself with the parts of the
Lifecycle exercise bike and make sure that you have received
all the items described in the Parts List.
2.
Remove the STABILIZER BAR (#7) from the carton base. Use
the empty CONSOLE CARTON to raise the rear of the
LIFECYCLE exercise bike as shown.
Remove the two BOLTS (#1) from the bottom of the SHIPPING
STABILIZER, save the BOLTS and store the SHIPPING
STABILIZER with the other shipping containers.
3.
Use the same two BOLTS that held the SHIPPING
STABILIZER in place to attach the STABILIZER BAR as shown.
Make certain that the BOLTS are tight and the STABILIZER
BAR is flush against the frame. Remove the shipping carton.
4.
Unfold the CONSOLE WIRE HARNESS from the POST
extending from the FRAME.
NOTE: THE COLLAR (#4) SHOULD ALREADY BE IN PLACE
INSTALLED ON THE HANDLEBAR ASSEMBLY (#5). IF NOT,
INSTALL BEFORE PROCEEDING.
5.
Place the HANDLEBAR ASSEMBLY (#5) on the floor in front of
the FRAME with the two CONNECTORS next to each other.
Align the two CONNECTORS and push them together until they
firmly snap into place.
6.
Position the HANDLEBAR ASSEMBLY (#5), with the COLLAR
(#4) in place, so that the HANDLEBAR is facing away from the
user. Slide the HANDLEBAR ASSEMBLY into the HANDLEBAR
POST. Be careful not to pinch the wires.
Align the three holes in the HANDLEBAR ASSEMBLY (#5), with
those in the HANDLEBAR POST and install the three
HANDLEBAR BOLTS (#1).
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRES WHEN
PASSING THE BOLTS THROUGH THE HOLES. TIGHTEN THE
BOLTS SECURELY.
7.
Slide the COLLAR (#4) down until it completely covers the
HANDLEBAR ASSEMBLY HARDWARE and the HANDLEBAR
POST. Secure the COLLAR by squeezing the sides and
pushing downward firmly.
7
B
A
C
1
8P
1
5
5
4